Marisa Potgieter
- Total activity 504
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 252
Articles
Recent activity by Marisa Potgieter-
impact-training-criteria-for-when-a-vac-comes-out-of-impact-training-mode
Before a VAC comes out of impact training mode there must be at least 30 impacts, 1 hour of motion, 1 usage record from the time that the feature was enabled. If the criteria is not met the VAC wi...
-
query-to-confirm-checklist-nprofilenum
OSHA Sync & Checklist Issues Multiple ‘active’ profiles assigned (in the database) to the same ‘nProfileNum’ will cause an issue. As a result, the sync data will tell the VACs that they need N ch...
-
temp-xxxxxxxx-users-are-created-after-going-into-reg-id-mode
This is the source of the Temp-xxxxxxxx users. Each source is not dependent on the other. 1) Even if the software is in Registered ID mode, if the VAC does not have a synced Employee list it will...
-
cellular-wam-installation-guide
Installation document for cellular WAM hardware, including: How to mount the WAM How to verify the WAM installation WAM Electrical Verification Click the image below to download this document.
-
ipsec-wam-quick-start-guide
**Instructions and diagram for installation of an IPSec WAM. Click the attachment below to download the guide.** Attachments QSG IPSec WAM INSTALL.pdf
-
how-is-the-landmark-location-determined-for-an-event-inside-of-one-or-more-overlapping-landmarks
If an event or asset location appears inside of two or more landmark boundaries defined by a customer, the following criteria are used in order by the VeriWise system to determine the most appropr...
-
system-configuration-profile-authorization-tab
Setting the Login Type to Local will allow the VAC to choose it's Prox configuration: Prox, Wiegand, ibutton as opposed to imposing a prox type from the software. The System profile will apply the...
-
client-reports-that-the-iporttrucknotcomm-report-they-received-contains-duplicate-vehicle-names
BRIEF DESCRIPTION Client reports that the iPORTTruckNotComm report they received contains duplicate vehicle names. CAUSE One of the duplicated vehicles listed is a vehicle that was previously del...
-
sensor-hub-errors
-
speed-pulse-min-max-requirements
The minimum peak to peak voltage required for a speed sensor signal is 100 - 200 mv and max is 5v PP