Behavior Profiles - Profile Detail Screen - Behavior Profile Descriptions
The following list provides descriptions of the Behavior Profiles available for configuration in the system.
| Battery Level | Configuration that lets you set a minimum battery voltage or % of charge threshold. Once the battery level is outside the threshold, events are created and the operator can be alerted on the VAC if configured to do so. |
| Battery Swap | When enabled, requires a battery ID to be presented to the VAC after a VAC power loss of 30 seconds or more. Operators cannot log into the vehicle until the battery ID is presented. |
| Checklist Critical Response | Creates events when an operator selects a critical answer to a checklist question. |
| Checklist Non-compliance | Creates events and takes configured actions when the safety inspection and/or job selection is not selected within the available time period. |
| Grace Period Timers | Settings for when to activate idle timeout, hibernate and sleeper mode. |
| Impact | Creates events and actions based on specific severity levels of impacts recorded. |
| Indicator Actions | Creates events and takes actions based on high engine temperature and low oil pressure events. |
| Job Selection | Assigns a checklist and rules for picking the job an operator is performing. |
| Maintenance Completion | Assigns a checklist for maintenance personnel to complete when they perform planned maintenance on a vehicle. The completion of this checklists restarts predictive maintenance report parameters. |
| Message Alerts | Creates a VAC ‘beep’ when new text messages are received. |
| Multi-Vehicle Access Violation | Creates events when a single operator ID is logged into multiple vehicles simultaneously. Also allows the operator ID to be suspended. |
| Occasional Safety Inspection | Prompts operators to complete a checklist at a defined time interval (daily, weekly, monthly, annually, every N days, every N days since last checklist completed). |
| Parking Brake Monitor | When enabled, requires the parking brake to be applied before an operator can log off. |
| Remote Security Shutdown | Locks vehicle when security shutdown is enabled in the software. |
| Safety Inspection Checklist | Assigns a checklist and rules for operators to complete vehicle safety inspections. |
| Speeding | Configuration that lets you set a maximum speed threshold. Once the speed is outside the threshold for the configured amount of time, events are created and the operator is alerted on the VAC. |
| Zone Violations | Assigns a zone profile to the VAC whereby actions and events are created when the vehicle enters one of the zones within the profile. |
Behavior Profiles - Profile Detail Screen - Overview
The top section of the Behavior Profile detail screen displays the profile's description and the number of vehicles it has been assigned to.
The behavior sequence section displays each behavior's triggering condition, the vehicle response, and the action required to resolve it.
Behavior Profiles - Profile Detail Screen - Add a Behavior Profile
Click Add in the top right of the screen to add a new behavior profile.
A new profile will open — enter the behavior profile details.
Some behaviors support multiple entries while others allow only one. To add additional entries where supported, click Add Behavior.
Select a behavior from the window that opens, and click OK to return to the profile screen.
The behavior is added to the profile.
Configure any applicable options and use the up or down arrows on the behavior header to adjust its priority, where 1 is the highest and 30 is the lowest.
Click Save at the bottom of the screen when finished.
Behavior Profiles - Profile Detail Screen - Edit a Behavior Profile
Click Edit in the bottom right of the detail screen to edit a behavior profile.
In edit mode, behaviors are organized into sections separated by header bars displaying the behavior name.
Use the options on the right side of each header bar to reorder the behavior using the arrows or by editing the sequence number, delete it using the X, or expand and collapse the section using the caret icon.
Configure any available options within each behavior section, then click Save when finished.
Behavior Profiles - Profile Detail Screen - Delete a Behavior Profile
Click Edit in the bottom right of the detail screen to begin deleting a behavior profile.
Click Delete at the bottom of the screen.
A confirmation window will appear — click OK to confirm the deletion.